Used Motor Oil Treatment Machine For Base Oil in Sudan
- Use: Cooking Oil
- Type:Cooking Oil Machine
- Production Capacity: 3-600kg/Batch
- Power: : 500 W
- Dimension(L*W*H): 218x80x179cm
- Weight: 360 KG, 360kg
- spiral axes rotate speed(r/min): 28-40
- Market: Sudan
Used Motor Oil Treatment: Turning Waste Oil Into Valuable
apparatus by ASTM D97. The flash point of fresh motor oil. is 232 °C, for used engine o il flash point is 1 78°C, formic. acid treatment method flash point is 230°C, sulphuric acid. treatment
extractant, either as a single solvent or as a composite solvent, is used to extract the base oil from used oil [ 85]. After. solvent addition, a mixture of solvent and used oil is stirred over
Used Motor Oil Treatment: Turning Waste Oil Into Valuable
Key words: Used engine oil, motor oil, acid/clay treatment, recycling, waste oil recovery Full length article Received: 14-01-2014 Revised: 04-05-2015 Accepted: 15-05-2015 Available online: 31-05-2015 *Corresponding Author, e-mail: [email protected], Tel:0201002706756 1. Introduction Motor oil is used for lubricating various internal
A proper treatment technology allows us to remove priority pollutants (polyaromatic hydrocarbons, toxic metals, chlorinated hydrocarbons) from used oil, so used motor oil can be re-refined to base lubricating oil, processed into fuel oil or applied as stocks for petroleum-based production. Some used motor oils have a high contamination level
Used Motor Oil Treatment: Turning Waste Oil Into
Used engine oils specific gravity increases with the presence of increasing amounts of solids in the used engine oil. Fig. 1 shows the results for the used and fresh motor oils are 0.96 and 0.869 [15] respectively, while those treated oils obtained by the acid treatments methods were: 0.915 for treating with formic acid, 0.93 for phosphoric
Removal of water: After collecting the waste engine oil into the oil collection tank, it is placed in the refining pot, and after heating to 70-80 ℃, stop heating, let it stand for about 24 hours, drain the surface of the clear water, and then Slowly heat up to 120 ℃ (when the oil temperature is close to 100 ℃, heat slowly to prevent oil from boiling), so that the water evaporates, after
Some aspects of the regeneration of used motor oil
The research investigates the effect of different alcohols used in acid treatment of used motor oil and the influence of the bleaching treatment on the properties of the regenerated oil. The used motor oils are contaminated by contaminants and impurities resulted from undesirable oxidation processes: sediment, water, metallic particles
Solvent extraction. The used oil was subjected to filtration before treatment using a Buchner funnel. Approximately, 200 mL of the used oil was mixed with a combination of solvents (toluene, isopropyl alcohol, and ethanol at a ratio of 1:1:1) or single solvent (isopropyl alcohol) at a solvent-to-oil ratio of 1:1 or 2:1.
Model Prediction and Optimization of Waste Lube Oil Treated
In this work, used lube oil was treated using natural acid-free clay. Clay was added at different amounts (5, 10, and 20 g) to 100 mL of waste engine oil at various temperatures (250, 350, 400, and 450 °C) and mixed at a speed of 800 rpm for 30 min. After settling and separation, the treated oil was diluted with kerosene before being examined using a Ultraviolet–visible (UV
The most important used oil recycling technology is the re-refining. With these processes high quality base oil can be produced. Re-refining of Egyptian local crankcase used lubricating oil by … Expand
